International Journal of Aquaculture, 2026, Vol.16, No.5, 354-361 http://www.aquapublisher.com/index.php/ija 356 2.3 Morphometric measurements The following 12 morphometric characters were recorded: total length (TL), standard length (SL), body depth (BD), head depth (HD), caudal fin length (CFL), head length (HL), pre-dorsal length (PDL), pre-anal length (PAL), eye diameter (ED), pectoral fin length (PFL), dorsal fin length (DFL) and anal fin length (AFL). Standard length was used as the reference measurement because it excludes variation associated with the caudal fin. 2.4 Allometric analysis and size adjustment The relationship between each morphometric character and standard length was evaluated using the logarithmic equation: logY=loga+blogSL where Y represents the morphometric character, a is the intercept and b is the species-specific allometric coefficient. The coefficient obtained for each character was then used to adjust individual measurements for differences in body size. The resulting adjusted values were used for subsequent multivariate analyses. The size adjustment followed the allometric transformation specified in the original methodology: Madj =M SLmean SL b where Madj is the size-adjusted morphometric measurement, (M) is the observed measurement, (SL) is the standard length of the individual fish, SLmean is the observed mean standard length of the corresponding species used as the reference size, and (b) is the species-specific allometric coefficient obtained from the regression of the log-transformed morphometric measurement against log-transformed standard length. Thus, the adjustment was species-specific, with each species standardised to its own observed mean standard length rather than to a single reference length applied across all three species. The reference standard length was based on the observed mean SL of each species. For Lutjanus agennes, the mean standard length was 28.8642 cm, with an observed range of 12.90-45.60 cm (n = 405). For Pseudotolithus senegalensis, the mean standard length was 36.5891 cm, with an observed range of 26.00-48.50 cm (n = 405). For Polydactylus quadrifilis, the mean standard length was 21.2689 cm, with an observed range of 11.00-68.00 cm (n = 405). Therefore, the reference length was species-specific and was not a common standard length applied across the three species. The use of the observed species-specific mean standard length provided a common size basis within each species while retaining the size distribution represented by the sampled specimens. The adjusted measurements were consequently centred on the observed mean size of each species rather than on an arbitrarily selected body size. This approach reduced the influence of allometric size differences while preserving the proportional characteristics of the sampled fish. The adequacy of the size adjustment was assessed by examining the relationship between each size-adjusted morphometric variable and standard length. A negligible or non-significant residual relationship was interpreted as evidence that the influence of overall body size had been adequately reduced. This assessment was performed after transformation to determine whether systematic size-related variation remained in the adjusted morphometric variables. Total length (TL) was excluded from the PCA and CDA predictor set because SL was selected as the reference measure of overall body size. Total length incorporates the caudal-fin region and is closely related to the same general size dimension being controlled in the analysis. Its inclusion after standardisation could therefore provide limited additional information on body proportions and introduce redundancy among the morphometric variables. The analysis consequently focused on morphometric characters representing body, head, and fin proportions relative to SL.
RkJQdWJsaXNoZXIy MjQ4ODYzNA==